Xbox 360 Jtag

Tony Madden

Lives in Stockton-on-Tees · View My Profile

Lives in Stockton-on-Tees

£10

Xbox 360 Jtag

Price:

£10

Location:

Stockton-on-Tees, Co. Durham

Description:

Xbox 360 jtag

Fully tested and Assembled JTAG lead for use on Xbox 360 Consoles.

Please confirm that your box can be modded as follows !
Confirm your dashboard is ok
The very first thing you need to check, is your xbox kernel and that your XBOX is manufacture before June 18, 2009.
· Turn on your xbox and go to console settings.
· Go to system info, the kernel version is on top right.

Kernel Vulnerability:

8498 and Higher - Any console with a kernel 8498 and higher have been patched to stop the hack...

7371 and lower - Any console with the 7371 kernel or a lower version of the kernel can most likely be hacked.

7371 - This is the "iffy" kernel. With this kernel you have to dump your NAND to make sure that you have a vulnerable CB.

Some consoles with this kernel already have the patch applied to them and cannot be JTAG'd.

::::::::::::::::::::::::::::::::::::::::::::::::::::

The Lead is fully assembled and colour coded to help with installation.
This lead will allow you to flash your NAND with different software to recover your DVD key (even without the drive).
This kit is suitable for Xenon, Opus, Zephyr, Falcon and Jasper chipsets.

Although the lead is assembled, soldering IS required. You will be provided with a complete step-by-step guide to using your lead and how to install it into your Xbox.
All components are securely insulated from shorting and also colour coded for easy following in the step-by-step guide.
Installation will require you to open your Xbox 360 and void your warranty.
Installation is easy, Solder in the leads 7 wires, bridge 3x points with the resistor pack included and then just plug the JTAG lead in to your PC.
In this kit there is a jtag and other cables needed, which is a 3 lead bridge cable with integrated resistors and sealed in heatshrink,
2 colour coded wires with diodes soldered to them and sealed in heatshrink and 1 loose diode as all but Xenon need the 3rd diode..
It comes with printed instructions (plus further in depth info on cd) for all types of motherboards (see below on which can be done)
on how to read, save and re-write your nand chip and in doing so get the right flash onto your box.
There are support Forums to help you if you get stuck, and a link to any files needed.
My customers have stated over and over again that this is the best LPT jtag kit around, and who am I to argue, and I have sold over 500 ?

I do not fit these or jtag your box for you!

This jtag connects to your computer via 25 way parallel port (Lpt printer port) and you will need a 25 way male "D"
type to 25 way female "D" type connector parallel cable extension to use this, not the Centronics type.
Sorry I do not sell these extension cables

jtag £10.00 each

Sky box repairs as well.

Category:

Gadgets & Other Electronics

Reposted:

May 19 on Facebook